|
| |
|
|
| Product
Name |
:
|
Ethernet Module |
| |
|
|
| Model
No. |
:
|
EM120 |
| |
|
|
| Introduction |
:
|
The EM120 is Tibbo's new 10BaseT Ethernet-to-serial Module for onboard installation. Pin-to-pin compatible with, but slightly bigger than the EM200 100BaseT Module, the EM120 offers an advantage of significantly lower power consumption. The EM120 is upward-compatible with Tibbo's original EM100. To achieve smaller dimensions, the Module doesn't have Ethernet magnetics onboard*.
* To save space, use RJ45 connector with built-in magnetics. This will also result in significantly lower EMI |
| |
|
|
| Features |
:
|
lCompact, dimensions only 35x27.5x9.1mm
lLow power consumption of 50mA@5VDC
lOne 10BaseT Ethernet port; Ethernet magnetics not built in
lOne serial (TTL) port with full- or half-duplex operation**; baudrates of up to 115200bps; 5 parity modes (none, even, odd, mark, space); 7 or 8 data bits; optional RTS/CTS flow control
lSerial port includes RTS, CTS, DTR, DSR and five additional lines; all lines can be used as remotely controlled I/O
lFour LED lines*** provide Module status information
lTwo extended 4096-byte routing buffers
lOnboard EEPROM stores numerous user-definable functioning parameters (Setting)
lSupported network protocols include UDP, TCP, ARP, ICMP (PING) and DHCP
lModule setup can be performed through the serial port or network (over-the-network IP-address configuration is also supported)
lSpecialized "on-the-fly" commands for serial port control, "modem" commands to control network connections, status commands for remote status monitoring, etc.
lInternal firmware is upgradeable through the serial port or network
lSupplied with Device Server Toolkit (DST) for Windows, including Virtual Serial Port Driver (VSPD) (COM redirector)
lLINUX version of the VSPD is also available
lWorks with TIBBO.NET
lEM120-SK Starter Kit available
lCE- and FCC-approved
** Full-duplex mode is suitable for RS232 and RS422 comms., half-duplex mode- for RS485 comms. RS232/422/485 transceivers are not built in
*** LEDs must be connected externally
Learn more from: www.tibbo.com
|
|
